首页 > 其他 > 详细

Xhorse have revised Condor XC Mini va2 for PSA problem...

时间:2018-07-10 11:11:42      阅读:60      评论:0      收藏:0      [点我收藏+]

标签:condor mini key machine   Condor XC-MINI   CONDOR XC-MINI Master   iKeycutter CONDOR XC-MINI      

I had problem today with xhorse condor xc mini cutting VA2 for PSA. See the photo. I cut F C A A E A. The problem is at 1055-790. It mustn’t be a straight line at the bottom.

Condor mini KM03 cuts a straight line for the top layer then cuts correctly at the deeper layer. The cutting curve isn’t the same for the 1 mm depth. It looks like a worn key after cutting. I ask the developers to check it.

It’s a common VA2 for PSA. It isn’t custom. I attached a high resolution photo. If you see that area what I mentioned in my previous post you can see two different curve.

  1. straight line - it is the top layer (low depth)
  2. correct curve - lower layer (high dept up to 1mm)

The straight line cut the top of the correct curve.

Finally, Xhorse support have revised VA2 for PSA problem. Just need to update when the Condor XC Mini version is ready(it’s processing).


 original:Xhorse have revised Condor XC Mini va2 for PSA problem

Xhorse have revised Condor XC Mini va2 for PSA problem...

标签:condor mini key machine   Condor XC-MINI   CONDOR XC-MINI Master   iKeycutter CONDOR XC-MINI      

(0)
(0)
   
举报
评论 一句话评论(0
0条  
登录后才能评论!
multidigagj2534
加入时间:2016-12-13
  关注此人  发短消息
multidigagj2534”关注的人------(0
multidigagj2534”的粉丝们------(0
© 2014 bubuko.com 版权所有 鲁ICP备09046678号-4
打开技术之扣,分享程序人生!
             

鲁公网安备 37021202000002号