Linux 执行partprobe命令时遇到Unable to open /dev/sr0 read-write (Read-only file system)

[root@getlnx14test scsi_device]# fdisk /dev/sde

The number of cylinders for this disk is set to 19581.

There is nothing wrong with that, but this is larger than 1024,

and could in certain setups cause problems with:

1) software that runs at boot time (e.g., old versions of LILO)

2) booting and partitioning software from other OSs

   (e.g., DOS FDISK, OS/2 FDISK)

Command (m for help): p

Disk /dev/sde: 161.0 GB, 161061273600 bytes

255 heads, 63 sectors/track, 19581 cylinders

Units = cylinders of 16065 * 512 = 8225280 bytes

   Device Boot      Start         End      Blocks   Id  System

/dev/sde1               1       15665   125829081    5  Extended

/dev/sde2           15666       17231    12578895   83  Linux

/dev/sde5               1       15665   125829049+  83  Linux

Command (m for help): n

Command action

   l   logical (5 or over)

   p   primary partition (1-4)

p

Partition number (1-4): 3

First cylinder (17232-19581, default 17232): 17232

Last cylinder or +size or +sizeM or +sizeK (17232-19581, default 19581): 

Using default value 19581

Command (m for help): w

The partition table has been altered!

Calling ioctl() to re-read partition table.

WARNING: Re-reading the partition table failed with error 16: Device or resource busy.

The kernel still uses the old table.

The new table will be used at the next reboot.

Syncing disks.

[root@getlnx14test scsi_device]# partprobe

Warning: Unable to open /dev/sr0 read-write (Read-only file system).  /dev/sr0 has been opened read-only.

[root@getlnx14test scsi_device]# 

[root@getlnx14test scsi_device]# partprobe /dev/sde

[root@getlnx14test scsi_device]#